End belt receiver

End belt receiver

The receiver clips act as an end-point for Skipper retractable barriers, and can also be used to support the Skipper waste & safety management accessories.  As with the support brackets, the receiver clips are available in both magnetic and non-magnetic variants.

Skipper wall and magnetic receiver clips attach retracting barriers to any surface.  Simply pull out the tape from any Skipper or Skipper XS unit and slide it into the receiver clip. This will end the barrier without using additional Skipper units, cones or posts. Waste and safety management products such as recycle bins, safety dispensers and sanitizer brackets can be attached directly to the receiver clip. Wall version requires 4 x screws (not included).

• The Skipper magnetic receiver (Soft pads to prevent scratching to surfaces) clips allow the tape end to attach direct without the need for another Skipper unit. The non-marking magnetic version is perfect for attaching the end clip to vehicles and metal shelving. Simply place the receiver clip onto the desired metal surface. Any Skipper tape end clip will then slide into the receiver clip.

The magnetic receiver clip has soft pads inserted into the back of the screw holes to prevent scratching to metal surfaces. You should purchase the wall receiver clip if you intend to screw the clip into position.

• The Skipper wall receiver clips allow the tape end to attach direct without the need for another Skipper unit. Unlike the magnetic version, the wall receiver clips are intended for permanent/semi-permanent fixture. Simply screw the receiver clip into the desired position. Any Skipper tape end clip (including the XS unit) will then slide into the receiver clip.

Specification

• Depth: 23 mm

• Width: 80 mm

• Height: 100 mm

Minimum order quantity 5 pieces - Combination is possible [email protected]

Complete your set with other skipper products

Voor B2B aanvragen graag emailen naar [email protected].

For International inquiries and shipping please contact us at [email protected].